Experimental Study on the Anisotropy of the Tensile and Shearing Strength of Coal Rock

CUI Yueming, LI Yuwei

Abstract


The tensile and shearing strength of coal rock accurately obtained by test can provide important parameters for the design of coal seam fracturing and mine support system. Due to coal bedding and cleat developed, the experimental results will exist voluminous discreteness and can’t accurate determine the tensile and shearing strength, ignoring the influence of loading direction and bedding and cleat development direction, In this paper, the tensile and shearing strength is measured by laboratory experiment, counting and analyzing divergence of different direction according to experimental results, obtaining the relationship between the tensile and shearing strength and the bedding and cleat development direction. This research confirms that the tensile and shearing strength of coal rock exists the characteristic of anisotropy and it should not only take the average value of the test results of different direction simply in engineering application. On the other hand, it can supply experimental consideration and method to confirm the tensile and shearing strength required by the relevant construction design.
Key words: Coal rock; Tensile strength; Shearing strength; Anisotropy


Keywords


Coal rock; Tensile strength; Shearing strength; Anisotropy

Full Text:

PDF

References


[1] Ranjith, P. G., & Perera, M. S. A. (2012). Effects of cleat performance on strength reduction of coal in CO2 sequestration. Energy, 45(1), 1069-1075.

[2] Perera, M. S. A., Ranjith, P. G., Viete, D. R., & Choi, S. K. (2012). Parameters influencing the flow performance of natural cleat systems in deep coal seams experiencing carbon dioxide injection and sequestration. International Journal of Coal Geology, 204, 96-106.

[3] Rodrigues, C. F., Laiginhas, C., Fernandes, M., Lemos de Sousa, M. J., & Dinis, M. A. P. (2014). The coal cleat system: A new approach to its study. Journal of Rock Mechanics and Geotechnical Engineering, 6(3), 208-218.

[4] Cai, Y. D., Liu, D. M., Zhang, K. M., Elsworth, D., Yao, Y. B., & Tang, D. Z. (2014). Preliminary evaluation of gas content of the No. 2 coal seam in the Yanchuannan area, southeast Ordos basin, China. Journal of Petroleum Science and Engineering, 122, 675-689.

[5] Meng, Y. J., Tang, D. Z., Xu, H., Li, C., Li, L., & Meng, S. Z. (2014). Geological controls and coalbed methane production potential evaluation: A case study in Liulin area, eastern Ordos basin, China. Journal of Natural Gas Science and Engineering, 21, 95-111.

[6] Qu, X. R., Wu, J. W., & Shen, S. H. (2014). Experimental study on calculation of the tensile strength of coal based on the point load test. Journal of Engineering Geology, 22(6), 8-11.

[7] Li, N., Sun, Z. Y., & Song, D. Z. (2013). Experimental study on acoustic emission characteristic of raw coal failure under splitting test and uniaxial compression. Safety in Coal Mine, 10(1), 45-51.

[8] Fu, J. H., Huang, B. X., & Liu, C. Y. (2011). Study on acoustic emission features of coal sample Brazilian splitting. Coal Science and Technology, 39(4), 25-28.

[9] Yan, L. H., & Wu, J. W. (2002), Test and analyze of tensile strength of coal in Huaibei Yangzhuang coal mine. Coal Science and Technology, 30(5), 39-41.

[10] Wu, J. W., & Fan, C. (2003). Laboratory test on tensile strength of coal piece by sleeve fracturing technique. Coal Geology & Exploration, 31(1), 17-19.

[11] Yan, Z. F. (2009). Research of the coal mechanical properties and coal reservoir fracturing simulation in Jincheng district, Shanxi province (Doctoral dissertation). China University of Geosciences (Beijing), Beijing, China.




DOI: http://dx.doi.org/10.3968/6301

Refbacks

  • There are currently no refbacks.


Copyright (c)



Share us to:   

Reminder

  • How to do online submission to another Journal?
  • If you have already registered in Journal A, then how can you submit another article to Journal B? It takes two steps to make it happen:

1. Register yourself in Journal B as an Author

  • Find the journal you want to submit to in CATEGORIES, click on “VIEW JOURNAL”, “Online Submissions”, “GO TO LOGIN” and “Edit My Profile”. Check “Author” on the “Edit Profile” page, then “Save”.

2. Submission

  • Go to “User Home”, and click on “Author” under the name of Journal B. You may start a New Submission by clicking on “CLICK HERE”.

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
[email protected]; [email protected]; [email protected]

 Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY). 

ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office

Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.

Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:[email protected];  [email protected]

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures