Research on Injection Capacity of Polymer Flooding in Sublayers in Daqing Oilfield

Wenlong ZHANG, Bing ZHAI, Kaoping SONG, Mei WANG

Abstract


According to the application of numerical simulation method, this paper firstly analyzed the single factor including the reservoir parameters, chemical agent parameters, injection parameters and well spacing. And established the single factor regression formula of polymer injection pressure, then designed the orthogonal test scheme of different parameters. The paper also calculated the injection pressure increment of different scheme by the numerical simulation method, and established the multi factor quantitative formula between pressure increment and the factors based on multiple regression analysis. Through the application of field examples, the error between the calculation result of model and the actual result is within the allowable range of project. After Verifying the reliability of injection capacity model, it could provide theoretical support for injection capacity analysis of polymer flooding and injection scheme design.

Keywords


Numerical simulation method; Polymer flooding; Orthogonal test scheme; Injection pressure increment; Multiple regression analysis

Full Text:

PDF

References


[1] Standiford, B. B. (1964). Laboratory and field studies of water floods using polymer solutions to increase oil recoveries. Journal of Petroleum Technology, 16(8), 917-922.

[2] Liu, Y. Z. (2006). Enhanced oil recovery polymer flooding. Beijing: Petroleum Industry Press.

[3] Han, D. K., & Chen, Q. L. (2001). Reservoir simulation basis. Beijing: Petroleum Industry Press.

[4] Li, J. L. (2007). Daqing oilfield second category block back on residual oil reservoir. Oil and Gas Field Surface Engineering, 26(5), 1-2.

[5] Chen, X. H. (2011). Cause analysis of high injecting pressure and measure of augmented injection in polymer injectors of SZ 36-1 oilfield. China Offshore Oil and Gas, 23(3), 189-192.

[6] Liu, J. Y. (2014). The study on the influence factors in the late period of polymer flooding and management strategy. Journal of Yangtze University (Natural Science Edition), 11(26), 103-109.

[7] Zhang, J. G. (2005). Analysis of the main factors affecting the viscidity of the solution of polymer. Fault-Block Oil & Gas Field, 12(1), 42-43.

[8] Xu, Y. A. (2014). Effect of viscosity on profile reversal and oil-displacement efficiency of polymer flooding in multilayer heterogeneity reservoir. Oilfield Chemistry, (4), 549-552.

[9] Han, P. H. (1999). Determination of reasonable polymer amount in polymer flooding. Petroleum Geology & Oilfield Development in Daqing, 18(1), 40-41.

[10] Li, Z. X., & Du, S. K. (2010). Test optimization design and statistical analysis. Beijing: Science press.

[11] Zhang, X. Q. (2005). Optimization of the injection parameters of sub-layers polymer flooding in Daqing Oilfield. Journal of Daqing Petroleum Institute, 29(4), 40-42.




DOI: http://dx.doi.org/10.3968/7293

Refbacks

  • There are currently no refbacks.


Copyright (c) 2015 Advances in Petroleum Exploration and Development



Share us to:   

Reminder

  • How to do online submission to another Journal?
  • If you have already registered in Journal A, then how can you submit another article to Journal B? It takes two steps to make it happen:

1. Register yourself in Journal B as an Author

  • Find the journal you want to submit to in CATEGORIES, click on “VIEW JOURNAL”, “Online Submissions”, “GO TO LOGIN” and “Edit My Profile”. Check “Author” on the “Edit Profile” page, then “Save”.

2. Submission

  • Go to “User Home”, and click on “Author” under the name of Journal B. You may start a New Submission by clicking on “CLICK HERE”.

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
[email protected]; [email protected]; [email protected]

 Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY). 

ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office

Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.

Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:[email protected];  [email protected]

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures