Study on Flow Parameters Measurement Experiment of Polymer Solution in Porous Media

Jianguang WEI, Yuanyuan MA, Guocheng ZHANG

Abstract


Due to the complexity of porous media and viscoelasticity of polymer solution, the flow behavior of polymer solution in porous media is more complex than that in the rheometer, and the flow regular pattern of polymer solution in porous media directly affects the formulation of polymer flooding projects. This paper designs experiment on flow parameters measurement of polymer solution (partially hydrolyzed polyacrylamide) in porous media, and the regular pattern of influence on resistance factor, residual resistance factor and flow viscosity in porous media caused by core permeability, polymer concentration, polymer molecular weight and polymer injection rate was given. The followings are the results: even for the same batch core with similar parameters, due to reasons such as natural fractures which could lead to comparatively large difference of core parameters between the same batch of core, thus in order to ensure the reliability of experiment data, it is necessary to detect core quality before core flooding experiment. Core end effect has significant effect on the results of core flooding experiment, it suggests that we should eliminate the effect of core end effect when carry out core flooding experiment, otherwise it is difficult to obtain valid experiment data. There exists a critical polymer concentration, when polymer concentration is lower than critical concentration, resistance factor is basically equal to apparent viscosity; when polymer concentration is higher than critical concentration, resistance factor is far less than apparent viscosity and the difference value increases with the increase of polymer concentration. Flow viscosity of polymer solution in porous media is far less than apparent viscosity in the rheometer and when polymer concentration increases, the increase extent of flow viscosity is far less than the increase of apparent viscosity. Results of this research are of great importance for enhancing flooding effect and guiding oilfield production.


Keywords


Polymer solution; Porous media; Resistance factor; Apparent viscosity; Flow viscosity

Full Text:

PDF

References


[1] Harvey, A. H., & Menzie, D. E. (1970). Polymer solution flow in porous media. Society of Petroleum Engineers Journal, 10(2), 111 - 118.

[2] Morris, C. W., & Jackson, K. M. (1978, April). Mechanical degradation of polyacrylamide solutions in porous media. Paper presented at SPE Symposium on Improved Methods of Oil Recovery, Tulsa, Oklahoma.

[3] Huang, H. Y., Zhang, F. S., Callahan, P., & Ayoub, J. A. (2011, January). Fluid injection experiments in two-dimensional porous media. Paper presented at SPE Hydraulic Fracturing Technology Conference, The Woodlands, Texas, USA.

[4] Seright, R. S., Fan, T., Wavrik, K., & Balaban, R. C. (2011, March 1). New insights into polymer rheology in porous media. SPE Journal, 16(1), 35-42.

[5] Zhang, G. Y., & Seright, R. S. (2013, September). Effect of concentration on HPAM retention in porous media. Paper presented at SPE Annual Technical Conference and Exhibition, New Orleans, Louisiana, USA.

[6] Wang, L., Wang, Y. W., Pu, H., Zhang, C. L., Yin, D. Y., & Wang, L. P. (2012, April). Study on high-concentration polymer flooding in Lamadian oilfield, Daqing. Paper presented at SPE EOR Conference at Oil and Gas West Asia, Muscat, Oman.

[7] Xie, K., Lu, X. G., Li, Q., Jiang, W. D., & Yu, Q. (2016, February). Analysis of reservoir applicability of hydrophobically associating polymer. SPE Journal, 21(1), 1-9.

[8] Sheng, J. J., Leonhardt, B., & Azri, N. (2015, March 1). Status of polymer-flooding technology. Journal of Canadian Petroleum Technology, 54(2), 116-126.

[9] Hatzignatiou, D. G., Moradi, H., & Stavland, A. (2013, June). Experimental investigation of polymer flow through water- and oil-wet berea sandstone core samples. Paper presented at EAGE Annual Conference & Exhibition incorporating SPE Europec, London, UK.

[10] Sun, W. J., & Li, K. W. (2014, October). Experimental evaluation of models for calculating shear rates of polymer solution in porous media. Paper presented at SPE Annual Technical Conference and Exhibition, Amsterdam, The Netherlands.

[11] Kawale, D., Boukany, P. E., Kreutzer, M. T., Rossen, W. R., & Zitha, P. L. J. (2015, August). Contribution of pore-shape to the polymer apparent viscosity. Paper presented at SPE Asia Pacific Enhanced Oil Recovery Conference, Kuala Lumpur, Malaysia.

[12] Clarke, A., Howe, A. M., Mitchell, J., Staniland, J., & Hawkes, L. A. (2015, August). How viscoelastic polymer flooding enhances displacement efficiency. Paper presented at SPE Asia Pacific Enhanced Oil Recovery Conference, Kuala Lumpur, Malaysia.




DOI: http://dx.doi.org/10.3968/8567

Refbacks

  • There are currently no refbacks.


Copyright (c) 2016 Jian-Guang Wei, Yuan-Yuan Ma, Guo-Cheng Zhang

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

Share us to:   

Reminder

  • How to do online submission to another Journal?
  • If you have already registered in Journal A, then how can you submit another article to Journal B? It takes two steps to make it happen:

1. Register yourself in Journal B as an Author

  • Find the journal you want to submit to in CATEGORIES, click on “VIEW JOURNAL”, “Online Submissions”, “GO TO LOGIN” and “Edit My Profile”. Check “Author” on the “Edit Profile” page, then “Save”.

2. Submission

  • Go to “User Home”, and click on “Author” under the name of Journal B. You may start a New Submission by clicking on “CLICK HERE”.

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
[email protected]; [email protected]; [email protected]

 Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY). 

ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office

Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.

Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:[email protected];  [email protected]

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures