A New Analytical Model of Productivity Prediction for Offshore Heavy Oil Reservoir With Cycle Steam Stimulation by Horizontal Wells

Dong LIU, Jianbo CHEN, Tinghui HU, Caiqi ZHANG, Zhou FANG, Jifeng QU, Yike LUO

Abstract


The heavy oil thermal recovery technology has been widely used in land oil field both at home and abroad, but no precedent of offshore thermal recovery (except beach) was reported so far because of the platform limitation and operating cost restriction. Offshore thermal recovery needs higher oil recovery rate and higher cumulative oil production of each well. As for an offshore heavy oil reservoir, which can produce oil by natural energy of formation, the ratio of thermal productivity and cold productivity (oil productivity increment factor) decides whether development by thermal recovery or not. Due to the huge investment of offshore oil field development, too high or too low productivity evaluation will have serious consequences for oilfield exploration and development, so it is very important to make reasonable prediction of the relative oil productivity index (ROPI). Due to the complexity, there is no prediction model of ROPI for horizontal well CSS. Based on horizontal well productivity formula for cold production, on the basis of heated radius of CSS horizontal well, combining with the viscosity-temperature curve of heavy oil, considering the viscosity changes with temperature in heated area, a new analytical model of CSS horizontal well productivity prediction is derived. By the new model, it is easy to get the ROPI of CSS. The research results show that thermal recovery ROPI mainly influenced by heated radius, reservoir thickness and horizontal section length. Case study of CSS horizontal well in N heavy oil field in Bohai shows that, the average oil productivity of first injection cycle is 1.5 ~ 1.6 times of that of cold production, and it is in accordance with that of the prediction model. The new analytical model fills the gap between the complex numerical simulation method and simple experience method, which is of great significance for designing reservoir project of offshore heavy oil.


Keywords


Heavy oil; Horizontal well; Cycle steam stimulation; Productivity prediction; Analytical model

Full Text:

PDF

References


[1] Liu, W. Z. (1997). Steam injection for thermal recovery of heavy oils (1th ed.). Beijing: Petroleum Industry Press.

[2] Liu, D., Zhang, Y. C., Li, Y. P., Zhang, L., Hou, D. M., Li, J. M., & Liu, Y. C. (2014, May). Multi-thermal fluids stimulation production characteristics: A case study of the first thermal recovery pilot test for offshore heavy oil in China. Paper presented at 2014 World Heavy Oil Congress, New Orleans, USA.

[3] Liu, H. Q., Fan, Y. P., & Zhao, D. W. (2000). Principles and methods of thermal oil recovery technology (pp.138-141). Dongying, China: China University of Petroleum Press.

[4] Yang, C. Z., & Han, D. K. (1991). Present status of EOR in the Chinese petroleum industry and its future. J. Pet. Sci. Eng., 6, 175-189.

[5] Friedmann, F., Smith, M. E., Guice, W. R., Gump, J. M., & Nelson, D. G. (1994). Steam-foam echanistic field trial in the midway-sunset field. SPE Reserv. Eng., 4, 297-304.

[6] Jabbour, C., Quintard, M., Bertin, H., & Robin, M. (1996). Oil recovery by steam injection: Three-phase flow effects. J. Pet. Sci. Eng., 16, 109-130.

[7] Fatemi, S. M., & Jamaloei, B. Y. (2011). Preliminary considerations on the application of toe-to-heel steam flooding (THSF): Injection well-producer well configurations. Chem. Eng. Res. Des., 89, 2365-2379.

[8] Liu, D., Ma, K. Q., Zhang, L., Nie, L. L., & Li, J. M. (2015, May). The research and first application of multi-thermal fluids huff and puff technology in Bohai bay offshore heavy oil in China. Paper presented at 2015 World Heavy Oil Congress, WHOC2015-153, Edmonton, Alberta, Canada.

[9] Huang, Y. H., Liu, D., & Luo, Y. K. (2013). Research on multi-thermal fluid stimulation for offshore heavy oil production. Special Oil & Gas Reservoirs, 20(2), 164-165.

[10] Joshi, S. D. (1996). Augmentation of well productivity with slant and horizontal well. Journal of Petroleum Technology, 6(4), 729-739.

[11] Don, H. E. (1999). Problems concerning the productivity calculation of horizontal well and branch horizontal well. Oil Drilling & Production Technology, 21(6), 56-59.

[12] Zhang, H. L., Zhang, Q., & Liu, Q. J. (2002). Study on transient performance for horizontal well with steam stimulation. Petroleum Drilling Techniques, 30(1), 56-58.

[13] Zhang, M. L., Liu, H. B., & Cheng, L. S. (2004). Non-isothermal inflow performance model for horizontal well in heavy oil reservoir with thermal recovery. Petroleum Exploration, 25(4), 62-66.

[14] Wang, Y. D., Hou, J., Chen, Y. M., & Gong, C. K. (2005). An analytical model to predict production for cyclic steam injection in horizontal wells. Petroleum Drilling Techniques, 33(2), 51-53.

[15] Wang, Z. H., Li, Z. P., & Zhao, Z. H. (2009). Analysis of influence factors on productivity of horizontal well. Fault-Block Oil & Gas Field, 16(3), 58–61.

[16] Liu, D. (2015). A new model for calculating heating radius of thermal recovery horizontal wells. China Offshore Oil and Gas, 27(3), 84-90.




DOI: http://dx.doi.org/10.3968/8742

Refbacks

  • There are currently no refbacks.


Copyright (c) 2016 Dong LIU

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

Share us to:   

Reminder

  • How to do online submission to another Journal?
  • If you have already registered in Journal A, then how can you submit another article to Journal B? It takes two steps to make it happen:

1. Register yourself in Journal B as an Author

  • Find the journal you want to submit to in CATEGORIES, click on “VIEW JOURNAL”, “Online Submissions”, “GO TO LOGIN” and “Edit My Profile”. Check “Author” on the “Edit Profile” page, then “Save”.

2. Submission

  • Go to “User Home”, and click on “Author” under the name of Journal B. You may start a New Submission by clicking on “CLICK HERE”.

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
[email protected]; [email protected]; [email protected]

 Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY). 

ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office

Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.

Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:[email protected];  [email protected]

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures